NCR S16 - Manual (Page 47)

Performing a Full Installation of Windows NT Server 4.0
NCR S16 Minitower Server Installing Network Operating System 5-11
3. When prompted to have the setup utility search for your network adapters,
choose Select from List and Have Disk.
4. Insert your network interface board driver disk. Select the appropriate
driver, and select NEXT.
Selecting Network Protocols
Continue the installation by selecting network protocols. Follow these steps:
1. The Windows NT Server installation procedure prepares your available
choices for network protocols. You may select any of the protocol
transports listed: NWLink (IPX/SPX), TCP/IP, or NetBEUI. When you
have selected the checkboxes of all protocols you want to install, select
NEXT.
2. Verify the network services that will be installed to the system. Make any
needed changes and select NEXT.
3. To install the selected components, select NEXT.
4. When prompted, setup your network boards, and select CONTINUE.
5. When prompted to configure the parameters for the TCP/IP transport, and
you chose to install it, ask your network administrator for information you
need to configure this service.
6. You may choose to enable the Dynamic Host Configuration Protocol, if
this system is to be connected to a DHCP server. If not, you must enter
the appropriate IP Address and Subnet Mask and the Default Gateway, if
routing outside of your local subnet.
7. You may also choose to enter the IP addresses of your primary and
secondary WINS server. When finished, select OK.
8. Installation of the network components continues. If you indicated earlier
that you want this system to be a Domain Controller, you are prompted to
choose if this system is to be a Primary Domain Controller or a Backup
Domain Controller. In either case, you must complete the domain name.
Note: Do not include spaces or backward slashes in the domain name.
When you have finished, select OK.