NCR S16 - Manual (Page 74)

SCO Release 3: Installing TCP/IP Communications
8-8 Installing SCO UNIX
6. Select your specific driver from the list and enter the corresponding
number at the prompt. If your driver is not listed, you must complete the
previous steps first.
7. When the “Add chain SCO_TCP->smpw0?” prompt displays, enter
“YES.”
8. Enter the correct internet address (IP) for this interface (192.0.0.1, for
example).
Completing the Installation
To complete the installation, follow these steps:
1. Use the default subnet mask for your chosen IP Class, or select the one
that matches your network.
2. Use the defaults.
3. At the “Verify?” prompt, enter “YES.”
4. Enter a “Local host name:”, such as “scosysv”. The “Adding host
name...” (to the /etc/hosts file) message displays.
5. At the “Host ttys?” prompt, use the defaults.
6. The TCP configuration is complete. Back at the beginning, “sco_tcp-
>smpw0” should now be listed.
7. At the “Relink kernel now?” prompt, enter “YES.”
8. At the “Boot by default?” prompt, enter “YES.”
9. Type “init 6” to shutdown and reboot; watch for errors.