Configuring the scsi adapters – NCR S16 User Manual

Page 23

Advertising
background image

Configuring the SCSI Adapters

NCR S16 Minitower Server Installing Network Operating System

3-3

Configuring the SCSI Adapters

To configure the SCSI adapters, if connected to an Adaptec SCSI adapter,
follow these steps:

1. Press Ctrl + A when the following displays:

Adaptec AIC-7880 Ultra/Ultra W BIOS
Press <Ctrl><A> for SCSISelect (TM) Utility

Refer to Chapter 5 of the NCR S16 Minitower Server User Guide
(BST0-2142-00) for additional information about these settings.

2. Select SCSI Disk Utilities. Verify that all the SCSI devices are displayed

with correct information. If a low-level format on the hard disk drive is
needed, perform it now. Usually it is not needed.

3. Select Configure/View Host Adapter Settings and set the parameters as

follows:

SCSI Bus Interface Definitions

Host Adapter SCSI ID

7

SCSI Parity Checking

Enabled

Host Adapter SCSI Term

Low OFF/High ON

Boot Device Options:

Boot Target ID

0

Boot LUN Number

0

4. Select SCSI Device Configuration and set the parameters as follows:

SCSI Device ID (tab to desired device)

Initiate Sync Negotiation

Yes

Maximum Sync Transfer Rate

20

Enable Disconnection

Yes

*

Initiate Wide Negotiation

Yes

*For Wide devices only.

Advertising