NCR S16 - Manual (Page 48)

Performing a Full Installation of Windows NT Server 4.0
5-12 Installing Microsoft Windows NT Server 4.0
9. If you previously indicated that you want this system to be a Server, you
are prompted to indicate the name of the domain or workgroup this system
will join.
Entering Additional Setup Information
Continue the installation by entering additional setup information. Follow
these steps:
1. When prompted, enter the current date, time, and time zone. After each
item has been entered, select CLOSE.
2. When prompted, select the video driver configuration, including the
resolution, number of colors, and scan rate.
3. After you have selected the desired parameters, select TEST to verify the
video displays the resolution correctly. Follow the instructions on the
screen to complete the test. When you are certain that the selections are
correct, select OK to configure the video driver. Your system’s
configuration is saved.
4. After windows NT Setup copies some files, you are prompted to insert a
blank high-density disk into the drive to create an Emergency Repair Disk.
This happens only if you chose to create an Emergency Repair Disk
earlier in the installation.
5. Insert the disk, and select OK. The disk is formatted and appropriate files
are copied to it.
6. When prompted, reboot your system.
After rebooting, the installation of Windows NT Server is complete.