Net2Phone Max 430 - Manual (Page 25)

Max 410/420/430 User’s Guide – Chapter 3
17
3 Connecting
the Max
410/420/430 to a LAN
Whether your LAN uses DHCP or static addresses, you
can set the Max 410/420/430’s LAN configuration in either
of two ways:
via a touch-tone keypad, or
through a serial connection via the
HyperTerminal terminal-emulator application.
This section explains how to set the Max 410/420/430’s
LAN configuration using either method.
This chapter describes:
Connecting the Max 410/420/430
to a DHCP LAN
Connecting to a LAN with static
IP addresses
NOTE: On a Max 410, LAN settings must
be configured using a PC with a serial
cable connection using the HyperTerminal
terminal emulator application, which is
included with all MS operating systems.
Connecting the Max 410/420/430 to
a DHCP LAN
This section explains how to connect your Web browser to
the Max 410, 420, or 430 if your LAN uses DHCP
addressing. If your LAN uses static IP addresses, skip to
Connecting to a LAN with Static IP Addresses, on page
20 in this Guide.
The default configuration for the Max 410, 420, and 430 is
for DHCP (Dynamic Host Configuration Protocol).
3