Net2Phone Max 430 - Manual (Page 79)

Max 410/420/430 User’s Guide – Chapter 6
71
On the New York City (local) Max unit:
The New York City Max’s four FXO ports have
been configured for Max-to-Max calling and
their Max-to-Max IVR setting is IVR Off.
Extension number 4000 on the PBX has been
assigned to this group. The group is configured
on the PBX as a hunt group so that, when
4000 is dialed from an extension on the PBX,
the PBX connects the caller to the first
available unoccupied port on the Max within
the group.
On the London (remote) Max unit:
The account number of the London unit is
1234567890.
The Welcome and Password option has been
selected on that unit’s Max-to-Max IVR Config
table.
Now we can proceed with the call.
1. Dial 4000 from your office PBX extension.
You hear an Internet dial tone.
2. Dial *72 + the remote FXO port’s account
number, e.g., *72 1234567890 #.
The Max in the London office greets you,
“Welcome to . Please enter your password.”
3. Enter the password.
The Max in London responds, “Please enter the
number you wish to call.”
4. Enter Windsor Castle’s city code and local
number as if you were dialing an inter-city call
from London: 0753 831118.
The voice prompts you receive from the remote
unit would depend on how its Max-to-Max IVR
options were configured.
Depending on the options set by the remote system’s
manager:
you might immediately be asked for a number
you wish to call,
you might be asked for a password, or