Net2Phone Max 430 - Manual (Page 30)

Max 410/420/430 User’s Guide – Chapter 3
22
addresses, using either a telephone keypad or serial
connection. The process will entail the following steps:
1. Disable DHCP in the Max 410/420/430.
2. Enter a static IP address.
3. Enter a netmask address.
4. Reset the unit.
5. Log in to the Max Web Manager.
6. Set the required configuration parameters in the
Max Web Manager.
Entering Static IP Addresses from a
Telephone Keypad
If your LAN uses static IP addresses, the most practical
way to set up the Max 420 or 430 is to enter an IP address
and netmask from a telephone keypad. You can then
finish setting up the unit while browsing the Max Web
Manager.
Disabling DHCP from a telephone keypad (Max
420/430)
Since the Max 410/420/430 is shipped with DHCP
enabled, you need to disable DHCP to use static IP
addresses. To disable DHCP, proceed as follows:
1. Connect an analog telephone to any RJ-11 port
on the Max 410/420/430.
2. Lift the handset and dial *** 5 (the disable DHCP
parameter code).
The voice prompt announces, “DHCP is disabled
now. Please press pound”.
3. Press the pound key ( # ).
4. Hang up the telephone.
DHCP is now disabled.