Net2Phone Max 430 - Manual (Page 86)

Max 410/420/430 User’s Guide – Appendix
78
upgrading to version 1.5.30, that setting may
not have been cleared by the upgrade process.
As a result, you must re-load the factory
defaults and re-enter your configuration
settings. The following steps walk you through
this process:
Before re-loading the factory settings, take
a snapshot of the configuration settings
you customized by printing each
configuration page in the Web Manager.
You will need to refer to this hard copy
later, after you have loaded the default
configuration and are ready to re-enter
your settings.
In the Web Manager, click the Load
Default Config link in the sidebar menu.
Click the Load button.
Reboot the device.
In the Web Manager, re-enter any settings
that you may have modified from the
original default configuration. Use the
hard copy of your configuration settings
(from the first step in this procedure).
NOTE: If you are still unable to send
faxes or the fax quality is poor,
contact Net2Phone Reseller Support.