NEC NEAX IPS NWA-008869-001 - Manual (Page 111)

CHAPTER 4 INITIALIZATION
– 101 – NWA-008869-001 Rev.1.0
atch4001.fm
SETTING UP THE LAN PORTS FOR SUITABLE COMMUNI-
CATION MODES
Set up the LAN ports for the communication modes suitable to the environment used.
This section uses the LAN1 (10/100BASE-TX) port as an example.
Setup method
To set up the LAN port for a specific communication mode, enter device config mode.
By default, the In-Skin Router is set up for automatic negotiation (auto negotiation) for both communica-
tion rate and communication direction.
Setting the communication rate
In this example, the communication rate is set to 10 Mbps.
Setting the communication direction
In this example, the communication direction is set to half duplex.
ix1000
− 01 # enable − config
ix1000
− 01 (config) # device FastEthernet0
ix1000 − 01 (config − FastEthernet0) # speed 10
ix1000 − 01 (config − FastEthernet0) #
Enter
Enter
Enter
ix1000 − 01 # enable − config
ix1000
− 01 (config) # device FastEthernet0
ix1000
− 01 (config − FastEthernet0) # duplex half
ix1000
− 01 (config − FastEthernet0) #
Enter
Enter
Enter
SETTING UP THE LAN PORTS FOR SUITABLE COMMUNICATION MODES