NEC NEAX IPS NWA-008869-001 - Manual (Page 112)

CHAPTER 4 INITIALIZATION
– 102 – NWA-008869-001 Rev.1.0
atch4001.fm
NOTE: When you connect a communication device (such as a HUB) to the LAN1 (10/100BASE-TX)
port of the In-Skin Router, and either the In-Skin Router or that communication device is set up
for auto negotiation, transfer efficiency may be impaired due to the mismatch between the com-
munication modes of these devices, although a link has been established.
If this occurs, set the communication rate of the LAN1 (10/100BASE-TX) port appropriately (to
10 Mbps, 100 Mbps, or auto negotiation), as well as the communication direction (to full du-
plex, half duplex, or auto negotiation), referring to the following combination table.
Checking of the settings
Check the settings with the show interfaces command.
Setting in the In-Skin Router Communication rate and direction assumed
if both the rate and direction of the opposite
device are set to auto negotiation
Rate Direction
Auto negotiation Auto negotiation 100 Mbps, full duplex
Auto negotiation Fixed at full duplex Undefined (may impair transfer efficiency)
Auto negotiation Fixed at half duplex 100 Mbps, half duplex
Fixed at 100 Mbps Auto negotiation 100 Mbps, full duplex
Fixed at 100 Mbps Fixed at full duplex Undefined (may impair transfer efficiency)
Fixed at 100 Mbps Fixed at half duplex 100 Mbps, half duplex
Fixed at 10 Mbps Auto negotiation 10 Mbps, full duplex
Fixed at 10 Mbps Fixed at full duplex Undefined (may impair transfer efficiency)
Fixed at 10 Mbps Fixed at half duplex 100 Mbps, half duplex
ix1000
− 01 (config − FastEthernet0) # exit
ix1000 − 01 (config) # show interfaces FastEthernet0.0
Interface FastEthernet0.0 is up
(Omitted)
FastEthernet statistics :
Physical address 00 : 00 : 4c : a4 : 03 : 18
Half − duplex, 10Mb/s, 100BaseTX
(Omitted)
ix1000 − 01 (config) #
Check the settings.
(In this example, half duplex,
10 Mbps)
Enter
Enter
SETTING UP THE LAN PORTS FOR SUITABLE COMMUNICATION MODES