NEC NEAX IPS NWA-008869-001 - Manual (Page 129)

CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 119 – NWA-008869-001 Rev.1.0
atch5001.fm
Checking the routing table
Use the show ip route command to check the information stored in the routing table.
Checking the communication state
Checking
Use the ping command to send a packet from terminal A to terminal B to check that communication can
be performed normally.
Router (config) # show ip route
IP Routing Table
− 3 entry
Code : C − Connected, S − Static, R − RIP, O − OSPF, IA − OSPF inter area
E1 − OSPF external type 1, E2 − OSPF external type 2,
*
− Candidate default
Timers : Age
R 192.168.1.0/24 [120/2] via 192.168.3.1, Ethernet0.0, 0 : 00 : 10
C 192.168.2.0/24 [0/1] is directly connected, FastEthernet0.0, 0 : 14 : 57
C 192.168.3.0/24 [0/1] is directly connected, Ethernet0.0, 0 : 14 : 44
Router (config) #
Enter
ROUTING SETUP EXAMPLES (IPv4)