NEC NEAX IPS NWA-008869-001 - Manual (Page 122)

CHAPTER 4 INITIALIZATION
– 112 – NWA-008869-001 Rev.1.0
atch4001.fm
Startup
Checking
Use the show running-config command to check the startup state of the telnet server.
Checking the communication state
Check the telnet communication inside the In-Skin Router and between remote consoles.
For checking, use the ping command for IPv4 and the ping6 command for IPv6, with the IP address of the
remote console specified. You can use the ping and ping6 commands in both global config mode and in-
terface config mode.
ix1000
− 01 (config − FastEthernet0.0) # exit
ix1000
− 01 (config) # telnet − server ip enable
ix1000 − 01 (config) #
Enter
Enter
ix1000
− 01 (config − FastEthernet0.0) # exit
ix1000
− 01 (config) # telnet − server ipv6 enable
ix1000
− 01 (config) #
Enter
Enter
ix1000 − 01 (config) # show running − config
(Omitted)
timezone + 9
telnet − server ip enable
telnet − server ipv6 enable
device FastEthernet0
device Ethernet0
Interface FastEthernet0.0
ip address 192.168.3.100/24
ipv6 address 3ffe : 200 : : 1/64
no shutdown
interface FastEthernet0.1
encapsulation pppoe
(Omitted)
ix1000
− 01 (config) #
Enter
Check that "enable" is
displayed.
SETUP FOR A REMOTE CONSOLE