Nortel Networks P0857846 - Manual (Page 117)

104 / User Preferences
Norstar-PLUS Modular ICS 2.0 System Coordinator Guide P0857846 Issue 02
The display buttons used in button programming.
Information about individual displays you may see is described at
the end of this section.
Changing User Speed Dial
• Press ≠ at User Speed Dial . The display shows the
number of speed dial codes that are available.
• Press ‘ to see the first speed dial code (71).
• Press ‘ to move through all the speed dial codes.
• Press ≠ at the code you want to change.
• Press CHANGE and enter the telephone number the same way
you would dial it on the telephone.
• Press OK .
• Press ‘ and choose the line (or enter a code for a line
pool) the speed dial code should use.
Use the line pool code to select a particular line pool for use with
Speed Dial. If you select
Use routing tbl , a line or pool will be
chosen by the routing programming according to the initial digits in
the number.
CANCL Moves you out of a setting without making any changes to it.
CLR Erases the button.
TEL# Programs the key as an autodial number for an internal or an
external number. If it is an external autodial number, you
have to choose a line, line pool, or the routing table for the
call to use.
CHANGE Used when you are setting up an external autodial number.
Press
CHANGE until you see the type of line or pool you want
the number to use.
FEATR Press to store a feature code on the button.
FIND Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
LIST Takes you to a list of feature codes. Press
‘
to
move through the list and press OK when you see the feature
you want to program on the button.