Nortel Networks P0857846 - Manual (Page 147)

134 / Using System features
Norstar-PLUS Modular ICS 2.0 System Coordinator Guide P0857846 Issue 02
For example, you can call a company with an automated attendant
that instructs you to dial the internal number you need. You can
program the company number, a Run/Stop, then the internal
number on one external autodial button. Press the autodial button
once to dial the company number. When you hear the automated
attendant, press the autodial button again to dial the internal
number.
The Run/Stop symbol ( fl ) uses one of the 24 spaces in an autodial
or speed dial sequence.
You can include up to three Run/Stop commands in a dialing string.
The system will ignore a fourth Run/Stop, and any digits or
commands that follow it in a programmed dialing sequence.
Wait for Dial Tone
Wait for Dial Tone causes a sequence of numbers to pause until dial
tone is present on the line before continuing to dial. This is useful if
you must dial a remote system and then wait for dial tone from that
system before dialing the rest of your number.
The Wait for Dial Tone symbol ( ‡ ) uses two of the 24 spaces in an
autodial or speed dial sequence.
Displays
Using pulse dialing for a call
If your external telephone lines use pulse dialing, you can
temporarily switch to tone dialing by pressing
£ after selecting the
line. Tone dialing lets your Norstar telephone communicate with
devices and services that respond to tone signals, such as
automatic switchboards, and fax or answering machines.
You have entered a code that can only be
used in a programmed autodial or speed dial
sequence, not on a call you dial directly.
Programmed Release and Run/Stop are for
use in programmed dialing sequences only.
ƒ°‚›