Me103 wireless access point rear panel, Restore to factory defaults button, Rj-45 ethernet port – NETGEAR ME103 User Manual

Page 21: Power socket, Me103 wireless access point rear panel -7, Restore to factory defaults button -7, Rj-45 ethernet port -7, Power socket -7

Advertising
background image

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

Introduction

2-7

August 2003

ME103 Wireless Access Point Rear Panel

Figure 2-2: ME103 rear panel

Left Side Primary and Right Side Secondary Detachable Antenna

The ME103 provides two detachable antenna. The one on the left is the primary, and the one on
the right is the secondary. See

“Understanding Advanced Wireless Settings” on page 5-8

and

“Antenna Installation” on page 5-13

for important information about configuring and

positioning the antenna to best take advantage of diversity and range capabilities of the ME103.

Restore to Factory Defaults Button

The restore to default button located between the Ethernet RJ-45 connector and the power
socket restores the ME103 to the factory default settings.

RJ-45 Ethernet Port

Use the ME103 Ethernet RJ-45 port to connect to an Ethernet LAN through a device such as a
hub, switch, or router.

Power Socket

This socket connects to the ME103 power adapter.

ETH ERN ET

RESET

5-12V D

C

Advertising