How to configure multi-point wireless bridging, How to configure multi-point wireless bridging -11 – NETGEAR ME103 User Manual

Page 61

Advertising
background image

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

Advanced Configuration

5-11

August 2003

4.

Verify connectivity across the LAN 1 and LAN 2.

•

A PC on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.

How to Configure Multi-Point Wireless Bridging

Figure 5-10: Multi-Point bridging

1.

Configure the Operating Mode of the ME103 Access Points.

–

ME103 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC
Address of AP2.

–

Because it is in the central location, configure ME103 (AP2) on LAN Segment 2 in
Point-to-Multi-Point Bridge mode. No MAC address is required because it will respond to
Point-to-Point APs which are configured communicating to it.

–

Configure the ME103 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote
MAC Address of AP2.

2.

Verify the following parameters for all access points:

•

Verify that the LAN network configuration the ME103 Access Points are configured to
operate in the same LAN network address range as the LAN devices

•

Only one AP is configured in Point-to-Multi-Point Bridge mode, and all the others are in
Point-to-Point Bridge mode.

"Master" ME103 in
Point-to-Multi-Point
Bridge Mode

LAN
Segment 1

192.168.0.1

Router

ME103 in
Point-to-Point
Bridge Mode

Hub or Switch

LAN
Segment 3

ME103 in
Point-to-Point
Bridge Mode

LAN
Segment 2

Hub or Switch

AP1

E T H E R N E T

R E S E T

5 - 1 2 V D C

AP3

E T H E R N E T

R E S E T

5 - 1 2 V D C

AP2

E T H E R N E T

R E S E T

5 - 1 2 V D C

Advertising