The wireless lan activity light does not light up, The lan light is not lit, The lan light is not lit -2 – NETGEAR ME103 User Manual

Page 66

Advertising
background image

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

6-2

Troubleshooting

August 2003

The Wireless LAN activity light does not light up.

The access point’s antennae are not working.

If the Wireless LAN activity light stays off, disconnect the adapter from its power source and
then plug it in again.

Make sure the antennas are tightly connected to the ME103.

Contact NETGEAR if the Wireless LAN activity light remains off.

The LAN light is not lit.

There is a hardware connection problem.Check these items:

Make sure the cable connectors are securely plugged in at the access point and the network
device (hub, switch, or router). A switch, hub, or router must be installed between the access
point and the Ethernet LAN or broadband modem.

Make sure the connected device is turned on.

Be sure the correct cable is used. Use a standard Category 5 Ethernet patch cable. If the
network device has Auto Uplink™ (MDI/MDIX) ports, you can use either a cross-over cable
or a normal patch cable.

I cannot access the Internet or the LAN with a wireless
capable computer.

There is a configuration problem.Check these items:

You may not have restarted the computer with the wireless adapter to have TCP/IP changes
take effect. Restart the computer.

The computer with the wireless adapter may not have the correct TCP/IP settings to
communicate with the network. Restart the computer and check that TCP/IP is set up properly
for that network. The usual setting for Windows the Network Properties is set to “Obtain an IP
address automatically.”

The access point’s default values may not work with your network. Check the access point
default configuration against the configuration of other devices in your network.

Advertising