Default factory settings, Default factory settings -3 – NETGEAR ME103 User Manual

Page 24

Advertising
background image

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

3-3

Basic Installation and Configuration

August 2003

Default Factory Settings

When you first receive your ME103, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see

“ME103

Wireless Access Point Rear Panel” on page 2-7

.

FEATURE

FACTORY DEFAULT SETTINGS

User Name (case sensitive)

admin

Password (case sensitive)

password

Operating Mode

Access Point

Access Point Name

NETGEARxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address

DHCP

DHCP client

IP Configuration

(if DHCP server is unavailable)

IP Address: 192.168.0.224
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Primary DNS Server:
blank
Secondary DNS Server: blank

Network Name (SSID)

NETGEAR

Broadcast Network Name (SSID

Enabled

802.11b

Radio Frequency Channel

11

WEP

Disabled

Restricting connectivity based

on MAC Access Control List

Disabled

WEP

Disabled

802.1x

Disabled

SNMP

Disabled

Advertising