Raritan Computer DOMINION KSX II - Manual (Page 239)

Chapter 12: Command Line Interface (CLI)
229
Telnet Connection to the KSX II
Due to the lack of security, user name, password and all traffic is in
clear-text on the wire. Telnet access is disabled by default.
Enabling Telnet
If you wish to use Telnet to access the KSX II, first access the KSX II
from the CLI or a browser.
To enable Telnet:
1. Select Device Settings > Device Services and then select the Enable
TELNET Access checkbox.
2. Enter the Telnet port.
3. Click OK.
Once Telnet access is enabled, you can use it to access the KSX II and
set up the remaining parameters.
Accessing Telnet from a Windows PC
To open a Telnet session from a Windows ® PC:
1. Choose Startup > Run.
2. Type Telnet in the Open text box.
3. Click OK. The Telnet page opens.
4. At the prompt enter the following command: Microsoft Telnet>
open <IP address> where <IP address> is the KSX II IP address.
5. Press the Enter key. The following message appears: Connecting
To <IP address>... The login as prompt appears.
Local Serial Port Connection to the KSX II
The local serial port of the KSX II must be connected to the COM port of
a computer system, a terminal, or some other serial capable device
using a null modem cable with DB-9F null on both ends.
If your KSX II's terminal port uses an RJ45 jack, a special cable (CRLVR)
is used with an ASCSDB9F connector on the client machine. The
CRLVR may also be used if RJ45-RJ45 connection to local port is
established - that is, if you connect the local port of a KSX II device as a
serial target to another KSX II.