Raritan Computer DOMINION KSX II - Manual (Page 31)

Chapter 2: Installation and Configuration
21
4. Set the Threshold slider to 1.0.
5. Click OK.
Accessing the Command Line
1. Right click.
2. Choose Tools > Terminal. A terminal window opens. (It is best to be
at the root to issue commands.)
Video Settings (POST)
Sun systems have two different resolution settings: a POST resolution
and a GUI resolution. Run these commands from the command line.
Note: 1024x768x75 is used as an example here; substitute the resolution
and refresh rate you are using.
To check current POST resolution:

Run the following command as the root: # eeprom output-device
To change POST resolution:
1. Run # eeprom output-device=screen:r1024x768x75.
2. Log out or restart computer.
Video Settings (GUI)
The GUI resolution can be checked and set using different commands
depending on the video card in use. Run these commands from the
command line.
Note: 1024x768x75 is used as an example here; substitute the resolution
and refresh rate you are using.
Card To check resolution: To change resolution:
32-bit # /usr/sbin/pgxconfig -prconf 1. # /usr/sbin/pgxconfig -res
1024x768x75
2. Log out or restart computer.
64-bit # /usr/sbin/m64config -prconf 1. # /usr/sbin/m64config -res
1024x768x75
2. Log out or restart computer.
32-bit
and
64-bit # /usr/sbin/fbconfig -prconf 1. # /usr/sbin/fbconfig -res
1024x768x75
2. Log out or restart computer.