Ricoh 170 / 180 - Manual (Page 133)

NOTE: This information is only for the Type I models.
When your machine receives a new voice message, it can call your programmed
station automatically. You can choose a paging number or a telephone number as
your station. If you choose the paging number and telephone number as your
station, the machine will call only the paging number.
If you follow the procedure below, your pger will display the sender’s telephone
number and message numbers when your fax machine has received a voice
message.
NOTE: You must program the paging telephone number first.
1. Press the Function key and
6,2,2,2,2,6,1 using ten keypad, then
press the Yes key.
Y/NEXT k
SET PAGING TEL NO.
2 If the above display has not appeared,
press the
k
key until the screen is as
shown above.
3. Press the Yes key. PAGING TEL KPAD
llllllllllllllllll
4. Input the paging telephone number that
you wish to use.
Example: 7227050552 , press
7,2,2,7,0,5,0,5,5,2 using the ten keypad.
PAGING TEL KPAD/Y/N
7227050552
5. Press the Yes key .
6. Finish: Press the Function key
1. Press the Function key and
6,2,2,2,2,6,2 using the ten keypad.
Then press the Yes key.
Y/NEXT k
SELECT LINE
2. Press the
k
key until " PAGING
ON/OFF " is displayed.
Y/NEXT k
PAGING ON/OFF