Ricoh 170 / 180 - Manual (Page 146)

Additional Information and Errata
[P51] Receiving with Auto Select mode
1. The machine starts ringing.
2. You have two options:
❐ Pick up the handset.
If you hear a voice then continue a normal conversation.
If you hear a tone then the other end is a fax machine. Make sure the
document feeder is empty, press the Start key to start receiving and replace
the handset. If you do not replace the handset or press the Start key, after a
few seconds the machine will automatically take the line and receive the
message.
❐ Do nothing. The machine will keep ringing. After a number of rings (the auto
ring time ) the machine will begin to receive a message. You can change
the number of rings (the auto ring time) - see page 49.
[P14, 92, 93 and 95] Opening the printer cover
The printer cover catch is located in the center of the
cover. To release the printer cover, you need to
squeeze the catch backwards - see opposite. The
cover will spring out a little. Then grasp the paper
guides and raise the cower up.
NOTE: The catch must be squeezed backwards. If
you apply too much pressure in the opposite
direction the catch will become detached from
the machine. If this happens, follow the instruc-
tions below.
Reattaching the printer cover catch
If your printer cover catch becomes detached, it can
easily be fixed. While holding the printer cover open,
push the catch back into position in the direction shown
opposite. The catch should click into place.
[P95] Replacing the carriage
If you close the printer cover and "
REPLACE
PAPER
" or "
CLEAR COPY
" is still displayed, please
check the position of the carriage. It should be on the
left side. If it is not in that position, slide it back to the left.
NOTE: If the carriage sticks halfway, the transparent
plastic strip may be blocking it - pull it out
slightly from the rear of the machine to let it
pass.
Part No. H0688697