Ricoh 170 / 180 User Manual
Page 48
Scanning Quickly (Memory Transmission, Type I Only)
1. Make sure that the machine is in
standby mode.
MEM.TX 100% 10:00AM
SET DOC. OR DIAL NO
❐
The display on the operation panel must
be as shown on the right.
2. If the display does not look like above,
then press the Line Select key.
3. Follow both steps in any order.
❐
Dial in one of the following ways:
TRANSMIT Y/STRT
3104719266
a) Ten Keypad
b) Quick Dial
c) Speed Dial
d) Handset*
*:Only if the telephone handset is installed.
If your machine is behind a PBX, dial the access code, then a pause, then the telephone numbers.
For international numbers, press the Pause key after entering the country code.
❐
Carefully place your fax message
face down into the auto document
feeder.
MEM.TX OPTIONk
DIAL FAX NUMBER
❐
The Pages must be placed down in the feeder with
the first page at the bottom of the stack.
❐
Feed the pages in so that the top edge goes in first.
❐
Do not feed in more than 10 pages.
❐
Do not use unsuitable type of original (see page
108).
❐
Adjust the document guides to fit the width of the
pages.
❐
Do not use pages of different sizes.
4. Press the Start key.
SAVING TO MEMORY
F-001 P.01 99%
❐
The machine will scan the document and dial.
File Number
Selecting Contrast and Resolution: See page 41.
Options for Sending a Message : See page 44.
Bad
Good
B
A
S
IC OPERA
T
IO
N
SENDING IMMEDIATELY VS. SCANNING QUICKLY
37