Oracle Audio Technologies Oracle Retail Place 12.2 - Manual (Page 56)

Setting Up the Place Installation
6-2 Oracle® Retail Place Installation Guide
database.<schema_name>.oracle.upgrade=yes
For more information on the installation properties file and the Plan installation
procedure, see the chapter
Installing Plan .
Setting Up the Place Installation
Before you start installing the Place application, you must edit the installation
properties file and direct the installer to create a new Place schema. Since the other
schemas are already created during Plan installation, you must direct the installer to
upgrade (and not create) the other schemas.
To set up the place schema properties for the Place application:
1. Edit the install.properties file to reflect the following settings in the Oracle
Properties (Place Schema) section:
database.placedb.oracle.create=yes
database.placedb.oracle.upgrade=no
For all other schemas, specify the following:
database.<schema_name>.oracle.create=no
database.<schema_name>.oracle.upgrade=yes
2. Run the Oracle Installer to start installing the Place application.
For more information on the installation properties file and the Place installation
procedure, see the chapter Installing Place in the Place Installation Guide.
Important: These parameter settings direct the installer to create a new Place
database schema. Ensure that you use these settings only when you are
installing the Place application over a Plan installation that does not have this
database schema installed before.
In case you are installing the Place application over an existing Plan-Place
co-deployed environment, since the Place database schema already exists, you
must set the value for the database.placedb.oracle.create parameter to no and the
value for the database.placedb.oracle.upgrade parameter to yes.