Quadra-Fire EDGE 60 ZERO CLEARANCE PELLET FIREPLACE 7051-158B - Manual (Page 51)

R
December 6, 2011 7051-158B Page 51
EDGE 60 Pellet Fireplace
C. Convection Blower Replacement
1. Follow the proper shut down procedures as outlined on
page 14, Section 3.A.
Figure 50.1
D. Baffl e Removal & Replacement
1. Follow the proper shut down procedures as outlined
on page 14, Section 3.A.
2. Open front and open fi rebox door.
3. The baffl e is located at the top inside of fi rebox.
4. To remove the baffl e:
a. Place a fl at head screwdriver into the slot of the
latches located in the upper corners. Figure
50.3.
b. Push down and the bottom of the latch will fall
forward off of the post.
c. Lift the baffl e up and then out toward you.
5. To replace the baffl e:
a. Place the 2 locating ears behind the bottom edge.
b. Tilt the baffl e up and into place.
The baffl e must be centered in the fi rebox before
latching it in place.
c. If it is not centered the latch is trapped between
the baffl e and side of the fi rebox instead of latch-
ing properly.
d. The bottom of the latches will fi t over the posts.
e. Push the top of the latch forward to lock latch into
place.
Baffle
Latches
Insert flat head screw driver into “V”
section and push down and the bottom
of the latch will fall forward off of post
Locating ears - 1 on
each side. Fit behind
bottom edge.
Figure 50.3
WARNING! Risk of Injury! Cast iron is a very heavy
material. The baffl e is made of cast iron and therefore is
heavy and awkward at times to maneuver. Clear and prepare
your work area before you begin.
2. Remove the 2 bolts from the bottom left and right side
of the fi replace and slide the fi replace out.
3. Locate the convection blower on the bottom left rear of
the fi replace. Reach behind the blower and release the
latch by pushing the top of the latch towards the blower.
Figure 50.1.
4. Rock the top of the blower slightly and lift up and out.
The blower will pass around the control board and out
the side of the fi replace.
5. Disconnect the wire harness from the bottom of the
blower by depressing the tabs on the sides of the con-
nector and then pulling to remove.
6. Re-connect wire harness to the new replacement
blower. Install the blower by placing the bottom fl ange
into the opening fi rst then rotate blower up into posi-
tion.
7. When the blower is properly positioned the latch will engage
the notch to hold the blower in place. Figure 50.2.
8. Slide appliance back in position and re-install bolts.
Release the Latch
Figure 50.2