Texas Instruments TMS320DM36X - Manual (Page 109)

www.ti.com Ethernet Media Access Controller (EMAC) Registers
5.29 MAC Control Register (MACCONTROL)
The MAC control register (MACCONTROL) is shown in Figure 68 and described in Table 66 .
Figure 68. MAC Control Register (MACCONTROL)
31 18 17 16
Reserved
R-0
15 14 13 12 11 10 9 8
Reserved RXOFFLENBLOCK RXOWNERSHIP RXFIFOFLOWEN CMDIDLE Rsvd TXPTYPE Reserved
R-0 R/W-0 R/W-0 R/W-0 R/W-0 R-0 R/W-0 R-0
7 6 5 4 3 2 1 0
Reserved TXPACE MIIEN TXFLOWEN RXBUFFERFLOWEN Rsvd LOOPBACK FULLDUPLEX
R-0 R/W-0 R/W-0 R/W-0 R/W-0 R-0 R/W-0 R/W-0
LEGEND: R = Read only; R/W = Read/Write; -n = value after reset
Table 66. MAC Control Register (MACCONTROL) Field Descriptions
Bit Field Value Description
31-15 Reserved 0 Any writes to these bit(s) must always have a value of 0
14 RXOFFLENBLOCK Receive offset/length word write block.
0 Do not block the DMA writes to the receive buffer descriptor offset/buffer length word.
1 Block all EMAC DMA controller writes to the receive buffer descriptor offset/buffer length
words during packet processing. When this bit is set, the EMAC will never write the third word
to any receive buffer descriptor.
13 RXOWNERSHIP Receive ownership write bit value.
0 EMAC writes the Receive ownership bit to 0 at the end of packet processing.
1 EMAC writes the Receive ownership bit to 1 at the end of packet processing. If you do not use
the ownership mechanism, you can set this mode to preclude the necessity of software having
to set this bit each time the buffer descriptor is used.
12 RXFIFOFLOWEN Receive FIFO flow control enable bit.
0 Receive flow control is disabled. Full-duplex mode: no outgoing pause frames are sent.
1 Receive flow control is enabled. Full-duplex mode: outgoing pause frames are sent when
receive FIFO flow control is triggered.
11 CMDIDLE Command Idle bit.
0 Idle is not commanded.
1 Idle is commanded (read the IDLE bit in the MACSTATUS register).
10 Reserved 0 Any writes to these bit(s) must always have a value of 0
9 TXPTYPE Transmit queue priority type.
0 The queue uses a round-robin scheme to select the next channel for transmission.
1 The queue uses a fixed-priority (channel 7 is highest priority) scheme to select the next
channel for transmission.
8-7 Reserved 0 Any writes to these bit(s) must always have a value of 0
6 TXPACE Transmit pacing enable bit.
0 Transmit pacing is disabled.
1 Transmit pacing is enabled.
5 MIIEN MII enable bit.
0 MII RX and TX are held in reset.
1 MII RX and TX are enabled for receive and transmit.
109 SPRUFI5B – March 2009 – Revised December 2010 Ethernet Media Access Controller (EMAC)/Management Data Input/Output
(MDIO)
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated