Texas Instruments TMS320DM36X - Manual (Page 73)

www.ti.com MDIO Registers
4.5 MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
The MDIO link status change interrupt (unmasked) register (LINKINTRAW) is shown in Figure 30 and
described in Table 27 .
Figure 30. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
31 16
Reserved
R-0
15 2 1 0
Reserved LINKINTRAW
R-0 R/W1C-0
LEGEND: R = Read only; R/W = Read/Write; W1C = Write 1 to clear, write of 0 has no effect; -n = value after reset
Table 27. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
Field Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1-0 LINKINTRAW 0-3h MDIO Link change event, raw value. When asserted, a bit indicates that there was an MDIO link
change event (that is, change in the LINK register) corresponding to the PHY address in the
USERPHYSEL register. LINKINTRAW[0] and LINKINTRAW[1] correspond to USERPHYSEL0 and
USERPHYSEL1, respectively. Writing a 1 will clear the event and writing a 0 has no effect.
0 No MDIO link change event.
1 An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register n (USERPHYSELn).
73 SPRUFI5B – March 2009 – Revised December 2010 Ethernet Media Access Controller (EMAC)/Management Data Input/Output
(MDIO)
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated