Toshiba RAS-10YKV-E - Manual (Page 33)

– 33 –
8-4. Auto Restart Function
This unit is equipped with an Automatic restarting
facility which allows the unit to restart and resume
the set operating conditions in the event of a power
supply shutdown without the use of the hand control.
The operation will resume without warning three
minutes after the power is restored.
The Auto Restart function is set not to work on
shipment from the factory, and so it is necessary to
set it to function as required.
8-4-1. How to Set the Auto Restart
To set the Auto Restart function, proceed as follows:
Access the TEMPORARY button located in the lower
right hand corner beneath the hinged front panel of
the indoor unit (please refer to Fig. 8-2-9). The
power supply to the unit must be on - the function
will not be set if the power is off.
To enable the Auto Restart function, push the
TEMPORARY button continuously for three
seconds.
The unit will acknowledge the setting and beep three
times. The system will now restart automatically.
The above Auto Restart settings can be carried out:
• When the system is stand-by (not operating)
• When the system is operating
Operation
Push the TEMPORARY button
continuously more than three
seconds.
Motion
Stand-by
↓
The system starts to operate. The green light goes on.
↓
about three seconds after
The unit beeps three times. The orange light goes on.
↓
The system is operating.
If the system is not required to run at this time, push the TEMPORARY
button once more or use the remote controller and the unit will stop.
Operation
Push the TEMPORARY button
continuously more than three
seconds.
Motion
Operating The green light goes on.
↓
The system stops to operate. The green light goes off.
↓
about three seconds after
The unit beeps three times.
↓
The system stops.
If the system is not required to stop at this time, use the remote
controller and to restart.
TEMPORARY
0
3S
TEMPORARY
0
3S
During subsequent operation, the orange light goes on.
• The Auto Restart function will not accept an
instruction if timer operation with the remote
controller is selected.
• During louver swing (AUTO) operation, after
restart by the Auto Restart function the louver
swing stops.