Toshiba RAS-10YKV-E - Manual (Page 60)

– 60 –
Horizontal grille Screw
Louver
motor
Hooks
Pipe
holder
Hooks fixing the
heat exchanger
Shaft bearing
base
Screw fixing the
heat exchanger
Hook
Screw
Cross Cross
flow fan
flow fan
Rear plate 6 to 7mm
Cross
flow fan
Shaft
bearing
base
Mount the fan motor
asshown in figure
belowwhen
assembling.
Put the end of lead
wire at the portion
between two ribs.
Ribs Ribs
Remarks No.
T
Procedure
1) Perform the process
R
.
2) Remove the screw fixing the louver motor, and
remove the louver motor.
3) Remove the shaft of the horizontal grille from the
drain-pan.
Part name
Horizontal grille
Note:
The horizontal
grille can not be
removed without
removing the
louver motor.
Heat exchanger
U
1) Perform the process
S
.
2) Remove the pipe holder from the rear side of main
unit by removing the screw.
3) Unhook the hooks fixing the left side of the heat
exchanger and remove the screw fixing it, then
remove the right side of the end plate from the rib
fixing the main unit by sliding the heat exchanger
slightly to the right side.
1) Perform the process
S
.
2) Loosen the set screw of the cross flow fan.
3) Remove the screw fixing the shaft bearing base.
4) Lift slightly up the left side of the heat exchanger,
and pull the shaft bearing base out left downwards.
When assembling it, fix it with the set screw on the
position where the gap between the rear plate surface
and the left end surface of the cross flow fan is 6 to 7
mm.
Cross flow fan
V
1) Perform the process
V
above.
2) Remove the shaft bearing from the shaft bearing
base.
<Caution for assembling>
• If a part of the shaft bearing is protruded from the
housing, assemble it after pushing its portion into
the correct position in the housing.
Shaft bearing
W
1) Perform the process
U
above.
2) Perform the process
V
-2) above.
3) Remove the left and right motor bands.
4) Remove the fan motor after pulling the cross flow
fan out sliding it left and right.
Fan motor
X