ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 460)

ZyWALL 2 Series User’s Guide
32-2 System Information and Diagnosis
monitor your ZyWALL. Specifically, it gives you information on your system firmware version, number of
packets sent and number of packets received.
To get to the System Status:
Step 1. Enter number 24 to go to Menu 24 - System Maintenance.
Step 2. In this menu, enter 1 to open System Maintenance - Status.
Step 3. There are three commands in Menu 24.1 - System Maintenance - Status. Entering 1 drops the
WAN connection, 9 resets the counters and [ESC] takes you back to the previous screen.
Figure 32-2 Menu 24.1: System Maintenance: Status
The following table describes the fields present in Menu 24.1 - System Maintenance - Status. These fields
are READ-ONLY and meant for diagnostic purposes. The upper right corner of the screen shows the time
and date according to the format you set in menu 24.10.
Table 32-1 System Maintenance: Status Menu Fields
FIELD DESCRIPTION
Port Identifies a port (WAN, or LAN) on the ZyWALL.
Menu 24.1 - System Maintenance - Status 09:41:41
Thu. Nov. 13, 2003
Port Status TxPkts RxPkts Cols Tx B/s Rx B/s Up Time
WAN Down 0 0 0 0 0 0:00:00
LAN 100M/Full 5818 6760 0 0 0 7:31:30
Port Ethernet Address IP Address IP Mask DHCP
WAN 00:A0:C5:00:00:02 0.0.0.0 0.0.0.0 Client
LAN 00:A0:C5:00:00:01 192.168.1.1 255.255.255.0 Server
System up Time: 7:31:36
Name:
Routing: IP
ZyNOS F/W Version: V3.62(WK.0)b1 | 10/24/2003
Press Command:
COMMANDS: 1-Drop WAN 9-Reset Counters ESC-Exit