ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 87)

ZyWALL 2 Series User’s Guide
WAN Screens 6-3
Figure 6-1 WAN Setup: Route
The following table describes the fields in this screen.
Table 6-3 WAN Setup: Route
LABEL DESCRIPTION
WAN
Traffic
Redirect
Dial Backup
The default WAN connection is "1” as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN. The default priority of
the routes is WAN, Traffic Redirect and then Dial Backup:
You have two choices for an auxiliary connection (Traffic Redirect and Dial Backup) in
the event that your regular WAN connection goes down. If Dial Backup is preferred to
Traffic Redirect, then type "14" in the Dial Backup Priority (metric) field (and leave the
Traffic Redirect Priority (metric) at the default of "15").
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
6.5 Configuring WAN ISP
To change your ZyWALL’s WAN ISP settings, click WAN, then the WAN ISP tab. The screen differs by the
encapsulation.
6.5.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.