ZyXEL Communications Internet Security Gateway ZyWALL 2 Series - Manual (Page 512)

ZyWALL 2 Series User’s Guide
37-6 VPN/IPSec Setup
Figure 37-4 Menu 27.1.1: IPSec Setup
You must also configure menu 27.1.1.1 or menu 27.1.1.2 to fully configure and use
a VPN.
The following table describes the fields in this screen.
Table 37-2 Menu 27.1.1: IPSec Setup
FIELD DESCRIPTION EXAMPLE
Index This is the VPN rule index number you selected in the previous menu. 1
Name Enter a unique identification name for this VPN rule. The name may be up
to 32 characters long but only 10 characters will be displayed in Menu
27.1 - IPSec Summary. Taiwan
Active Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to activate the VPN tunnel. This field determines whether a VPN
rule is applied before a packet leaves the firewall. Yes
Keep Alive Press [SPACE BAR] to choose either Yes or No. Choose Yes and press
[ENTER] to have the ZyWALL automatically re-initiate the SA after the SA
lifetime times out, even if there is no traffic. The remote IPSec router must
also have keep alive enabled in order for this feature to work. No
Menu 27.1.1 - IPSec Setup
Index #= 2 Name= zw2
Active= No Keep Alive= No Nat Traversal= No
Local ID type= IP Content=
My IP Addr= 0.0.0.0
Peer ID type= IP Content=
Secure Gateway Address= zw2test.zyxel
Protocol= 0 DNS Server= 0.0.0.0
Local: Addr Type= SINGLE
IP Addr Start= 1.1.1.1 End/Subnet Mask= N/A
Port Start= 0 End= N/A
Remote: Addr Type= SUBNET
IP Addr Start= 4.4.4.4 End/Subnet Mask= 255.255.0.0
Port Start= 0 End= N/A
Enable Replay Detection= No
Key Management= IKE
Edit Key Management Setup= No
Press ENTER to Confirm or ESC to Cancel: