ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 238)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
238
32.11.7 vdsl-profile Commands
The following table lists the vdsl-profile commands in configuration mode.
15minsLoss
<threshold>
Sets the number of Lost of Signal
(Los) errors allowed in any 15-minute
period. An alarm is triggered if this
number is exceeded.
13
15minsSESs
<threshold>
Sets the number of Severely Errored
Seconds(SES) errors allowed in any
15-minute period. An alarm is
triggered if this number is exceeded.
13
exit Exits from this command mode. 13
initFailure
<on|off>
Sets whether the device is to send an
initialization failure trap or not.
13
Table 84 vdsl-alarmprofile Commands (continued)
COMMAND DESCRIPTION P
Table 85 vdsl-profile Commands
COMMAND DESCRIPTION P
vdsl-profile
<name>
Enters VDSL profile command
mode.
13
applicablestandard <2> Sets a standard your switch uses
for VDSL services.
2: ETSI
13
bandplan <2> Sets a VDSL band plan to use for
the line.
2: Bandplan998
13
compatiblemode <1..4> Sets the starting band of the
frequency range used by VDSL
services.
1: none
2: 640kHz
3: 1100kHz
4: 2200kHz
13
deployment <1..2> Specify a VDSL deployment
scenario.
1: FTTCab
2: FTTEx
13
exit Exits from the VDSL profile
mode.
13
hamband mask
<00000000000..00
000111100>
Sets the device not to transmit
signals in the pre-defined HAM
(Handheld Amateur Radio) radio
band(s).
13
interleavedelay ds <0..255> Specify maximum interleave
delay for downstream traffic in
the slow channel.
13
us <0..255> Specify maximum interleave
delay for upstream traffic in the
slow channel.
13