ZyXEL Communications P-1100 - Manual (Page 119)

Prestige 1100 Internet Access Router
IP Policy Routing 13-5
Table 13-2 IP Routing Policy
Field Description
Policy Set Name This is the name of the policy set assigned in Menu 25 - IP Routing Policy
Setup.
Active Press the [SPACEBAR] to select [Yes] to activate the policy.
Criteria
IP Protocol IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Type of Service Prioritize incoming network traffic by choosing from [Don’t Care] / [Normal] /
[Min Delay] / [Max Thruput] / [Max Reliability].
Packet Length Enter the length of incoming packets (in bytes). The operators in the [Len
Comp] (next) apply to packets of this length.
Len Comp Press the [SPACEBAR] to choose from [Equal] / [Not Equal] / [Less] / [Greater] /
[Less or Equal] / Greater or Equal].
Precedence Precedence value of the incoming packet. Values range from [0] to [7] or [Don’t
Care].
Source:
addr start= /
end= Source IP address range from start to end.
port start= /
end= Source port number range from start to end; applicable only for TCP/UDP.
Destination:
addr start= /
end= Destination IP address range from start to end.
port start= /
end= Destination port number range from start to end; applicable only for TCP/UDP.
Action= Specifies whether action should be taken on criteria [Matched] or [Not
Matched].
Gateway addr Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it’s on the LAN, otherwise, the gateway must be the IP
address of a remote node. The default gateway is specified as 0.0.0.0.
Log Press the [SPACEBAR] to select [Yes] to make an entry in the system log when
a policy is executed.
Type of Service Set the new TOS value of the outgoing packet. Choose from Prioritize incoming
network traffic by choosing from [No Change] / [Normal] / [Min Delay] / [Max
Thruput] / [Max Reliability].
Precedence Set the new precedence value of the outgoing packet. Values range from [0] to
[7] or [No Change].