ZyXEL Communications P-1100 - Manual (Page 65)

Prestige 1100 Internet Access Router
IPX Configuration 6-7
Table 6-2 describes the IPX protocol-dependent parameters of the remote node Setup.
Table 6-2 Remote Node Novell IPX Options
Field Description Option
Rem LAN Net # In this field, enter the internal network number of the NetWare server
on the remote LAN.
My WAN Net # In this field, enter the network number of the WAN link. If you leave
this field as [00000000], your Prestige 1100 will determine
automatically the network number through negotiation with the PPP
peer. [00000000]
(default)
Hop Count This field indicates the number of intermediate networks that must be
passed through to reach the remote node. [1]
(default)
Tick Count This field indicates the time-ticks required to reach the remote node. [2] (default)
W/D Spoofing
(min) This field is for the Prestige 1100 on the server side. Your Prestige
1100 can spoof a response to a server’s WatchDog request after the
connection is dropped. In this field, type in the time (number of
minutes) that you want your Prestige 1100 to spoof the WatchDog
response.
SAP/RIP Timeout
(min) This field indicates the amount of time that you want your Prestige
1100 to maintain the SAP and RIP entries learned from this remote
node in its internal tables after the connection has been dropped. If
this information is retained, then your Prestige 1100 will not have to
get the SAP information when the line is brought back up. Enter the
time (number of minutes) in this field.
Once you have completed filling in the Network Layer Options Menu, press [ENTER] to return to Menu
11.1. Then press [ENTER] at the message [Press ENTER to Confirm] to save your configuration, press
[ESC] to cancel.