ZyXEL Communications P-1100 - Manual (Page 70)

Prestige 1100 Internet Access Router
7-2 Bridge Setup
From Menu 3 - Ethernet Setup, enter option 4. Bridge Setup for the appropriate LAN and Menu 3.4 -
Bridge Ethernet Setup displays as shown in Figure 7-1.
Figure 7-1 Menu 3.5 - Bridge Ethernet Setup
7.2.1 Remote Node Bridging Setup
Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For bridging-related parameters, you need to configure Menu 11.3 - Remote
Node Network Layer Options.
To setup Menu 11.3 - Remote Node Network Layer Options shown in Figure 7-2 Menu 11.3 -
Remote Node Bridging Options, follow these steps:
Step 1. In Menu 11.1, make sure the [Bridge] field is set to [Yes].
Step 2. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and set
the value to [Yes], and press [ENTER] to edit Menu 11.3 - Network Layer Options.
Menu 3.4 - Bridge Ethernet Setup
Bridge = No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.