ZyXEL Communications P-1100 - Manual (Page 49)

Prestige 1100 Internet Access Router
Remote Node Configuration 4-3
Field Description Options
Edit PPP Options To edit the PPP options for this remote node, move the
cursor to this field, use the space bar to select [Yes] and
press [Enter]. This will bring you to Menu 11.2 - Remote
Node PPP Options. For more information on configuring
PPP options, see the section Editing PPP Options. Press space bar
to toggle [Yes]
then press
[Enter]
Rem IP Addr This is a required field [?] if IP routing is enabled. Enter
the IP address of the remote gateway.
Edit IP/IPX/Bridge Options To edit the parameters, select [Yes] and press [ENTER].
This will bring you to Menu 11.3 – Remote Node Network
Layer Options. For more information on this screen, refer
to the chapter pertaining to your specific protocol. Press space bar
to select [Yes]
then press
[ENTER]
Session Options:
Input Filter Sets,
Output Filter Sets
In these fields, enter the filter set(s) you wish to apply to
the incoming and outgoing traffic between this remote
node and your Prestige 1100. You can choose from 12
different filter sets. In addition, you can link up to 4 filter
sets together for further customization, e.g., 1, 5, 9, 12.
Note that spaces are accepted in this field. For more
information on customizing your filter sets, see Chapter 8.
The default is blank, i.e., no filters defined.
Default= Blank
Once you have completed filling in Menu 11.1.1 - Remote Node Profile, press [ENTER] at the message
[Press ENTER to Confirm…] to save your configuration, or press [ESC] at any time to cancel.
4.2 Outgoing Authentication Protocol
Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor’s implementation includes specific authentication protocol in the user profile. It
will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.
4.3 Editing PPP Options
To edit the remote node options, move the cursor to the Edit PPP Options field in Menu 11.1 - Remote
Node Profile, and use the space bar to select [Yes]. Press [ENTER] to open Menu 11.2, as shown.