ZyXEL Communications P-1100 - Manual (Page 53)

Prestige 1100 Internet Access Router
Remote Node TCP/IP Configuration 5-3
The following diagram in Figure 5-3 explains the Sample IP Addresses to help you to understand the field
of My Wan Address in Menu 11.3.
192.168.1.0 10.0.0.0
172.16.0.2 172.16.0.1
Remote Network Local Network
192.168.1.1 10.0.0.1
Figure 5-3 Sample IP Addresses for a TCP/IP LAN-to-LAN Connection
To configure the TCP/IP parameters of a remote node, first configure the three fields in Menu 11 – Remote
Node Profile, as shown. For more details on the IP Option fields, refer to the Internet Access Application
Chapter.
Table 5-1 TCP/IP related fields in Remote Node Profile
Field Description Option
Route Make sure [IP] is among the protocols in the Route field in the
Remote Node Profile. [IP]
Rem IP Address Enter the IP address of the remote gateway in Menu 11.1 -
Remote Node Profile. You must fill in either the remote
Prestige WAN IP address or the remote Prestige LAN IP
address. This depends on the remote router’s WAN IP (for the
Prestige, the [My WAN Addr] in Menu 11.3 – Remote Node
Network Layer Options). For example, if the remote WAN IP is
172.16.0.2 (the remote router’s WAN IP), then you should
enter 172.16.0.2 in the [Rem IP Address] field. If the remote
WAN IP is 0.0.0.0, then enter 192.168.1.1(the remote router’s
LAN IP) in the [Rem IP Address] field.
Edit IP/IPX/Bridge Press the space bar to select [Yes] and press [ENTER] to go to
Menu 11.3 - Remote Node Network Layer Options Menu. [Yes]
([Yes/No])