ZyXEL Communications P-1100 - Manual (Page 120)

Prestige 1100 Internet Access Router
13-6 IP Policy Routing
13.2 Applying an IP Policy
This section shows you where to apply the IP Policies after you design them.
13.2.1 Ethernet IP Policies
From Menu 3 - Ethernet Setup, enter 2 to go to Menu 3.2 -General Ethernet Setup.
You can choose up to four IP Policy sets (from twelve) by entering their numbers separated by commas,
e.g., 2, 4, 7, 9.
Figure 13-4 Menu 3.1.1 - General Ethernet Setup
13.2.2 Remote Node IP Routing Policies
Go to Menu 11.3 (shown next) and enter the number(s) of the IP Routing Policy set(s) as appropriate. You
can cascade up to four policy sets by entering their numbers separated by commas.
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
DHCP Setup:
DHCP= None
Client IP Pool Starting Address= N/A
Size of Client IP Pool= N/A
Primary DNS Server= N/A
Secondary DNS Server= N/A
TCP/IP Setup:
IP Address= 192.68.0.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-2B
Multicast = IGMP-v2
IP Policies= 2,4,7,9
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.
Enter your IP
Policy sets
here.