Acnodes FPC 6104 - Manual (Page 27)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 6104
10.4” Industrial fanless Panel PC
4.5 Remove the Back Cover
4.5.1 FPC6104 Back Cover Removal
The back cover is secured to the chassis with nine retention screws, six on the rear
panel and three on the top panel (Figure 4-3). Remove the nine retention screws and lift
the cover off the FPC6104.
.6 Jumper Settings
he jumper settings are all described in Section 4.6. During normal installation, these
ettings should not be changed
.7 CompactFlash® Card Installationı
o install the a CF Type II card onto the FPC6104, please follow the steps below:
tep 1: Locate the CF card socket. Place the FPC6104 on an anti-static pad with the
solder side facing up. Locate the CF card socket.
tep 2: Remove the CF card socket cover. The socket cover is secured to the chassis
ith two retention screws. Remove the two retention screws to remove the socket
over. ı
tep 3: Align the CF card. Make sure the CF card is properly aligned with the CF
ocket.ı