Acnodes FPC 6104 - Manual (Page 37)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 6104
10.4” Industrial fanless Panel PC
Step 1: Align the mounting screws on the monitor rear panel with the mounting holes
on the bracket.
Step 2: Carefully insert the screws through the holes and gently pull the monitor down-
wards until the monitor rests securely in the slotted holes (Figure 4-21). Ensure that all
four of the mounting screws fit snuggly into their respective slotted holes.
NOTE:
In the diagram below the bracket is already installed on the wall.
Step 3: Secure the panel PC with the wall-mounting kit. To do this, stick the protective
cushion to the wall-mounting kit first. Then, put the wall-mounting kit on the top panel of
the panel PC. Carefully mark the location of the wall-mounting kit screw holes on the
wall. Drill a pilot hole at the marked location on the wall. Secure the wall-mounting kit to
the wall by inserting a retention screw into the pilot hole on the wall (Figure 4-22). This
step is to avoid the panel PC being pushed apart from the wall-mounting bracket acci-
dentally.