Fpc 6104 – Acnodes FPC 6104 User Manual
Page 31
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 6104
10.4” Industrial fanless Panel PC
4.10.1 ACCESS THE JUMPERS
To access the jumpers, remove the back panel. To remove the back panel, please refer
to Section 4.5.
4.10.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so may disable or
damage the system.
The following jumpers are preconfigured for the FPC6104. Users should no change
these jumpers (Table 4-2).
4.10.3 AT Power Select Jumper Settings
NOTE:
The AT Power Select Jumper is the same as the ATX Enable connector.
Jumper Label:
ATXCTl1
Jumper Type:
3-pin header
Jumper Settings:See Table 4-3
Jumper Location:
See Figure 4-16
The AT Power Select jumper specifies the systems power mode as AT or ATX. Use a
jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power
mode on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT Power
Select jumper settings are shown in Table 4-3.