Acnodes FPC 6104 - Manual (Page 39)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 6104
10.4” Industrial fanless Panel PC
4.10.2 Panel Mounting
4.10.2.1 FPC6104
To mount the FPC6104 flat panel PC into a panel, please follow the steps below.
Step 1: Select the position in the panel to mount the panel PC.
Step 2: Cut out a section from the panel that corresponds to the dimensions of the flat
panel PC chassis. The panel section that is cut out must be smaller than the size of the
aluminum frame that surrounds the TFT LCD panel but just large enough for the chassis
to fit through. Refer to Figure 4-23 and Figure 4-24 for the suggested cut out size.
Step 3: Slide the flat panel computer through the previously cut hole. The chassis at
the rear of the flat panel should slide easily through the hole. Only stop sliding the panel
through the hole when the back of the front aluminum frame is flush against the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the aluminum frame. There are a total of 8 panel mounting clamps
for FPC6104
Step 5: Tighten the screws that pass through the panel mounting clamps until the plas-
tic caps at the front of all the screws are firmly secured to the panel (Figure 4-25).