Acnodes FPC 6104 - Manual (Page 36)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 6104
10.4” Industrial Fanless Panel PC
4.10Mounting the System
WARNING!
When mounting the flat panel PC onto an arm, onto the wall or onto a panel, it is better
to have more than one person to help with the installation to make sure the flat panel
PC does not fall down and get damaged.
The four methods of mounting the flat panel PC are listed below.
Wall mounting
Panel mounting
Arm mounting
Rack mounting
The four mounting methods are described below.
4.10.1 Wall Mounting
To mount the FPC6104 flat panel PC onto a wall, please follow the steps below.
Step 1: Select the location on the wall for the wall-mounting bracket.
Step 2: Carefully mark the locations of the four bracket screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall for the bracket reten-
tion screws.
Step 4: Align the wall-mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (Figure 4-20).
Step 6: Insert the four monitor mounting screws provided in the wall mounting kit into
the four screw holes on the real panel of the monitor and tighten until the screw shank
is secured against the rear panel (Figure 4-21).