American Magnetics 185 & 186 Liquid Level Instruments (CE-Marked) User Manual
American Magnetics Equipment
Advertising
Table of contents
Document Outline
- Cover Page
- Declaration of Conformance
- Table of Contents
- Foreword
- 1 Introduction
- 2 Installation
- 2.1 Unpacking the Instrument
- 2.2 Rack Mounting the Instrument
- 2.3 Installing the Sensor in the Cryo-vessel
- 2.4 Connecting the Oscillator Cable to the AMI Sensor
- 2.5 Connecting the Instrument to the Oscillator
- 2.6 Installing an Optional Solenoid-operated Fill Valve
- 2.7 Connecting the Instrument to Power
- 3 Calibration
- 4 Operation
- 4.1 Normal Operations
- 4.1.1 Energize the instrument
- 4.1.2 Configure the active length setting
- 4.1.3 Configure the HI SETPOINT and the LO SETPOINT
- 4.1.4 Configure the A SETPOINT and the B SETPOINT
- 4.1.5 Select the operational mode of the controller output receptacle
- 4.1.6 Configure the INTERVAL setting (fill timer) if desired
- 4.1.7 Select the appropriate units display option
- 4.1.8 Connect the optional analog output signal
- 4.2 Sensor Contamination
- 4.1 Normal Operations
- 5 Remote Interface Reference
- 5.1 Serial Communication/Data Logger Option
- 5.2 IEEE-488 Communication Option
- 5.3 Error Codes
- 6 Virtual Instrument Operation
- 7 Service Guide
- Appendix
- Index