2 charging rack, 3 battery pack charger, 4 clips – AASTRA DT4x3 for BusinessPhone User Guide EN User Manual
Page 26: 5 security cord, 6 leather casing
AMT/PUD/TR/0119/1/2/EN 2012-08-13
User Manual
Cordless Phones for BusinessPhone™
20
There are two desk chargers available; one basic that only charges the handset, and
one with advanced functionality to download new software and to synchronize
parameters. The handset is fully operational while placed in the charger.
The charger is delivered with a plug-in power supply and is connected into an ordinary
wall socket. For more information, see the advanced charger’s Installation and
Operation Manual.
IMPORTANT:
When charging the EX classified handset, it is only permitted to use a
charger marked with DC3-BxxB or DC4-BxxB?on the label.
Note:
Only use the charger within the temperature range of +5° C – +40° C.
3.2.2
Charging Rack
The Rack PDM Charger is used for charging several handsets, to synchronize
parameters, and for software download.
IMPORTANT: If using the Rack PDM charger for charging EX classified handsets, it is
only permitted to use a rack charger marked with 87L00008AAAon the label.
The built in power supply can charge up to six handsets.
See the Charging Rack’s Installation and Operation Manual.
3.2.3
Battery Pack Charger
The Battery Pack Charger is used for charging up to six spare batteries.
IMPORTANT:
It is not permitted to charge EX classified batteries using the battery pack
charger.
See the battery pack charger’s Installation Guide.
3.2.4
Clips
Tip:
It is possible to use the handset without any clip on, see
on page 80. The belt clips cannot be used if the handset shall be placed in a case.
See
on page 20 for more information.
There are two belt clips available:
• Hinge-type clip?
?To prevent the handset from slipping out of for example pocket or belt, see
.
• Swivel-type clip
To be able to rotate without slipping out from for example pocket or belt, see
3.2.5
Security Cord
The security cord is 800 mm long. The security cord is attached directly to the handset.
3.2.6
Leather Casing
The leather casing is especially designed for the handset. The casing comes with a
swivel type belt clip and the handset is fully operational while placed in the casing.
.