AASTRA DT4x3 for BusinessPhone User Guide EN - Manual (Page 37)

AMT/PUD/TR/0119/1/2/EN 2012-08-13
User Manual
Cordless Phones for BusinessPhone™
31
6 Calling
6.1 Incoming Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset, gives a
notice of a call. Ring signal and vibrator can be disabled, see
8.8.1 Sound and Alert
Settings on page 56.
The calling party’s handset number or name is shown. The name will be shown if the
calling party’s handset number is stored in the local phonebook.
6.1.1 Answer a Call
When the signal sounds, press to answer the call, or press to answer the call in
loudspeaking mode 1 . The name/number of the calling party is displayed if calling line
information is available.
Tip: When a headset is connected to the handset, the headset button can be used to
answer the call. In addition, it is possible to configure the headset button with a specific
function, such as post-dial, dial last called number, or dial a predefined number. See
the handset’s Configuration Manual.
Other answering methods can also be set in the Settings menu, see 8.8 Settings on
page 56. The answering methods are; Automatically and Loudspeaking.
When Automatically is enabled, all incoming calls will be connected automatically.
Call Pick-Up
To answer a call to a phone in another room
1 Dial the number and press
2 When you hear a busy tone, Press 6
Note : Austria, Belgium, Brazil, Denmark and Germany Press 8; France and New
Zealand: Press 4.
6.1.2 End a Call
A press on ends the call. The duration of the call is shown in the display. The total
time of the call can also be retrieved from the Calls menu > Call time.
6.2 Outgoing Call
6.2.1 Pre-Dial
Enter the number and press to get the line. The number is shown on the display
while dialling. If needed, press "Clear" to erase the number. By using the navigation key
it is possible to step and add/delete a digit in a number.
It is possible to turn on the tone sender in a pre-dialled number by long pressing .
1.When Bluetooth is enabled, the loudspeaker audio is lowered due to current limitations in the intrinsically safe
handset.