AASTRA DT4x3 for BusinessPhone User Guide EN - Manual (Page 44)

AMT/PUD/TR/0119/1/2/EN 2012-08-13
User Manual
Cordless Phones for BusinessPhone™
38
7 Alarm Operation
The parameters described in this chapter are set in the WinPDM/CPDM3. See the
handset’s Configuration Manual.
Note: The alarm functionality is applicable for DT423/DT433 only.
7.1 Push-Button Alarm
The push-button can be defined to send an alarm by a long press and by
multiple press. By default, long press is defined for test alarm (see 7.1.1 Test Alarm ),
and multiple press is defined for personal alarm (see 7.1.2 Personal Alarm ).
7.1.1 Test Alarm
Press and hold the push-button until a dialog window "Test Alarm" (default) is
displayed. Depending on set parameters;
• a beep is heard
• the orange LED flashes twice
• the vibrator stirs
• the handset receives a notification that the alarm has been received by the system.
This is a system dependent feature.
• if configured, the ALS (see 7.3 Acoustic Location Signal on page 39) is activated
after the alarm has been sent, or a call is established to a pre-defined number (see
7.4 Automatic Call after Alarm on page 39)
7.1.2 Personal Alarm
Press the push-button twice or more, the dialog window "Personal Alarm"
(default) is displayed. Depending on set parameters;
• a beep is heard
• the orange LED flashes twice
• the vibrator stirs
• the handset receives a notification that the alarm has been received by the system.
This is a system dependent feature.
• if configured, the ALS (see 7.3 Acoustic Location Signal on page 39) is activated
after the alarm has been sent, or a call is established to a pre-defined number (see
7.4 Automatic Call after Alarm on page 39).
7.2 Man-Down and No-Movement Alarm
Man-down alarm: If the handset is tilted 45 degrees 6 or more for a preset time (default
7 seconds), the Man-down alarm will be triggered.
No-movement alarm: If no movement is detected during a preset time (default 30
seconds), the No-movement alarm will be triggered.
When an alarm is triggered, the following occurs;
• A Man-down warning. Cancel? or No- movement warning. Cancel? dialog window
is shown in the display, and a warning tone is also signaling during a period (default
7 seconds) before the alarm is sent.
6.The accuracy is -/+10 degrees.