Grain Systems PNEG-1797 - Manual (Page 30)

30 PNEG-1797CE CE Approved T-Series Tower Dryer
5. Operating Controls
Vision Control Panel Layout
Figure 5A
Vision controls are used on several GSI drying products. It can operate any dryer in either a batch or a
continuous flow mode. All operating instructions for the T-Series dryer describes continuous flow
operation only.
Heater switch
Fan switch
Load auger switch
Unload auger switch
Operator light switch
Control power switch
Stop switch Start switch Meter roll speed
Touch screen
WARNING
Switches on the vision panel are for control purposes only. For servicing and
maintenance switch OFF and lock at the main disconnect.