Xylem HYDROVAR Smart - Manual (Page 19)

19
9. TOTAL RUN TIME
0000:00
Runtime of the motor.
This time can be reset together with the
Operating hours.
Press the ¾ button to change to
Note: All changes have to be saved, that they will not be lost in case of shut off
of the power supply !!
10. SAVE ???
П + Р
Simultaneously press buttons Ï and Ð until...:
11. SAVE ???
SAVED
appears on the display. After five seconds the
display jumps back to the 1
st display.
These parameters can also be set during operation; To do so, briefly press the button ¾
and repeat steps 1 – 10.
Note: Often shown displays:
12. INVERTER LOCKED
enable inverter
This message appears when the connection of
terminal X1/4-X1/5 is open (external release contact).
To start the Hydrovar-Smart, connect these terminals by closing the external release contact
or by using a short-circuit connection!